Welcome to the official website of Shenzhen Eazylift Technology Co., Ltd.

All categories
搜索
sx
/
/
How to use the remote controller?

How to use the remote controller?

2019-12-16 10:05

  (1) The copyable remote controller can be copied with IC models of 2262/2260 / EV1527 / 2240; EV527 / HT6P40 and compatible ICs.

  (2) No need to consider oscillation resistance, this product is automatically compatible with oscillation resistance.

  (3) ICs that cannot be copied to the remote controller such as HCS300.HCS301 and compatible rolling ICs.

  (4) The copying remote controller has a fixed working frequency, commonly used is 315 / 433MHZ.

  Copy (copy) method:

  (1) Determine the operating frequency of the remote control and the chip number.

  (2) In order to clear the code that comes with the factory test, you can press the two buttons on the top of the universal remote control at the same time (must be at the same time, not for half a second). After 3 seconds, the LED indicator on the remote control starts Continuous flashing, indicating that the code inside the remote control has been cleared, then release it.

  (3) Keep the remote controller to be copied and this product as close as possible (the distance should be less than 10 mm, you can rotate around 360 degrees to find the best copy sensing point),

  (4) Press the first corresponding button on the universal remote control and the original remote control at the same time. After 3 seconds, the indicator light of the universal remote control continues to flash, indicating that the code of this button has been successfully copied, and then both are released. Then copy the second corresponding button, and press the second corresponding button on the universal remote controller and the original remote controller at the same time. After 3 seconds, the indicator light of the universal remote controller continues to flash, indicating that the code of this button has been successfully copied, and then both After releasing. Then copy the third and fourth buttons as above. Copy is complete.

  (5) If the original remote control has only two or three buttons, just copy a few buttons, and leave the extra buttons empty.

shareshareshareshare

  • ewm

    Alibaba

  • ewm

    WeChat

Hello, if you have any questions, please contact us, welcome to submit any questions and suggestions about us, we will reply you asap.. Thank you for your help. We are at your service 7 * 24

  • Tel: + (86) 755-33828381 Fax: (86) 755-33828386

  • Address: No. 9, Fuyu Road, Fucheng'ao Industrial Zone, Pinghu Street, Longgang District, Shenzhen

All rights reserved Shenzhen Eazylift Technology Co., Ltd.   ICP19124627  /  Powered by:www.300.cnShenzhen